Laid Down Stallions

I plan to offer Siesta/Pegaso & Beauty from 10th April 2022 to 10th June 2022 (at the latest) as open editions for that time frame in stablemate & venti scales - although I may close the edition early should interest taper off - or I may put a hold on orders (like I did with Herbert) so I could catch up - I am a 1 women team with a full time job and expecting 2 foals in May from my mares - and I want to keep wait times fair to all involved - trust me no one is more excited to see these boys in your hands than me!  

But I do request you realise each piece is printed to order I don't hold stock of them, and I have to work in batches to be efficient - but I am always happy to give you an update if you email me - just don't chase me daily! :P 

Please follow me on instagram to follow 'real-time' production/updates and you can see the behind the scenes of my previous edition too, so you know what to expect should you have any reservations about the 3d prints etc.  

As a very rough guide, my last edition took roughly 1 month from receiving your order to shipping it, but it depends on how popular they are, and my expecting 2 foals in May is likely to have an effect on turnaround times, which could cause me to pause the edition - basically the earlier you place your order the better :) 

If you missed my post on the purchase of ponies = planting trees - please check out the info here:

www.claritystudios.co.uk/plant-a-tree

NOTE:

Nearly all of my prototype images are raw copies with supports snapped off and not clean like your copies WILL be.  For production I cut each support with specialist cutters carefully after washing and before curing, then dremel, sand, polish and buff yours - they will just require usual to minimal prep. (This is what takes the time my end)

 Curios/ventis are printed hollow - and this process means drainage holes are needed for printing/rinsing.  I then fill these holes with apoxie sculpt and sand it down(these are not filled in on the prototypes in the images) - all hollow models require an air hole (like your breyers do) so please don't fill this.  It is usually a small hole on the underside of the models belly. 

There may be a slightly longer wait for Pegaso, especially venti scale as I can only print 1 at a time, each takes 17 hours to print, then a considerable amount of time to remove gently from the supports/clean.  His difference in price not only accounts for the additional time, work and resin the wings take, but also the fact he wont fit in a small box and weighs more (increasing shipping costs). I've done my best to keep him at a reasonable price point, and time pays are available as long as pif by 10th June :)